Clarify the three different actions
Weighing anchor recovers the anchor and cable through the windlass. It preserves equipment and normally produces a controlled departure, but it takes time and requires personnel forward.
Slipping anchor releases the cable at a designed connection or arrangement, leaving some or all of the ground tackle behind. It can be faster but still requires an approved sequence and exposed work.
Cutting cable is an extreme emergency action when normal release is unavailable or too slow. It creates serious personnel, recoil, equipment and navigation hazards. It can also leave an obstruction.
Crews should use precise language. “Get the anchor up” is not an adequate order when the plan is to slip. The bridge and forecastle must confirm which action, how much cable is out, the release point, propulsion readiness and the moment the vessel will be free.
Ship-specific procedures and risk assessment govern execution.
Decide whether movement is actually safer
The security case for moving can be strong. UKMTO's 2026 guidance notes that stationary and predictably operating ships can face small-craft, sabotage, mine, missile and drone threats. It says maintaining speed and using evasive manoeuvring can reduce vulnerability where safe.
But a stationary ship may have:
- cold or partially available machinery; - pilot or tug requirements; - incomplete cargo securing; - disconnected navigation sensors; - reduced bridge team; - personnel ashore; - open maintenance; or - no verified route through current threats.
Starting movement without resolving these can create collision, grounding, pollution or machinery casualty. An attack warning does not suspend the Collision Regulations or port authority controls.
The master should compare time to threat impact with time to achieve a controlled, navigable condition. If the ship cannot safely move before the threat arrives, protection, alarm, mustering and authority coordination may take priority.
Keep machinery at the readiness promised
An anchorage security plan should define propulsion notice and what “immediate,” “short notice” or another readiness status actually means. Test steering, communications and essential navigation equipment according to the plan.
When threat rises, reassess whether boilers, generators, fuel systems, air, cooling and bridge controls support the intended movement. Confirm the operating engineer and bridge team are at stations.
Do not report “engines ready” based only on a telegraph indication. State the tested capability and any limit. If propulsion is available but steering is not, freeing the ship can make danger worse.
Charterers and agents should understand that commercial maintenance or fuel-saving modes can lengthen escape time. They do not decide the master's safety readiness.
Record changes in readiness and the authority information that prompted them.
Protect the anchor party
The forecastle may be one of the most exposed locations during a drone, missile, small-craft or sabotage threat. It offers limited shelter and can be near the direction of approach.
Use the minimum competent team. Provide communications and protective equipment appropriate to the assessed threat. Confirm escape routes and safe positions. Stop the operation if personnel face unacceptable immediate danger.
The windlass, brake, stopper and cable carry enormous energy. Rapid release can produce uncontrolled movement, sparks, recoil and debris. No one should stand in the bight or expected path. A security emergency does not cancel seamanship.
If remote or protected release is available, crews need training in its limits. Improvised cutting tools should not become the default plan.
The bridge should keep the vessel's movement off the anchor under control. Propulsion applied at the wrong time can overload gear or endanger the team.
Account for the abandoned ground tackle
If the anchor or cable is left behind, record the best position, depth, amount and description of gear, time and method of release. Notify the port, VTS or coastal authority promptly so they can warn traffic and plan recovery.
An abandoned anchor can foul other ships, pipelines, cables or port equipment. A buoy or marker should be used only if safe, authorized and properly rigged. An improvised floating line can create another hazard.
Preserve windlass data, CCTV, logs and communications. Inspect the remaining shipboard arrangement for damage. A released cable may have damaged plating, hawse pipe or deck equipment.
Recovery is a later controlled operation. Do not return during an active threat solely to save property.
Contract and insurance questions about lost equipment, wreck removal and delay should follow accurate notification, not drive the emergency choice.
Coordinate without surrendering command
Contact the relevant port or coastal authority, VTS and maritime-security reporting centre. Ask about traffic, route restrictions, mine warnings, protective coverage and designated safe areas.
Authority information can materially change the decision. It does not remove the master's ultimate responsibility for the ship's safety and security, which IMO's maritime-security guidance emphasizes.
The company security officer should support the master with threat information and alternatives. One shore coordinator should reduce duplicate calls. Naval or port advice should be recorded accurately, including whether it was an order, recommendation or general warning.
A charterer may be informed of delay or deviation but should not press for a particular route or continued anchoring to protect laytime.
If the threat information is unverified, say so. A false warning can still create real collision risk if many anchored ships move at once.
Consider staying with safeguards
If movement is more dangerous, remaining at anchor still requires action. Increase watch, monitor approaches, restrict access, ready fire and damage-control teams, protect personnel and maintain machinery at the highest sustainable readiness.
Review blast exposure and move non-essential personnel from vulnerable spaces where the ship plan supports it. Keep rescue and medical arrangements ready. Coordinate patrol or authority support.
Reassess continuously. A choice to remain at 0200 is not a commitment to remain at 0210. Establish triggers for weighing or slipping, such as a verified contact crossing a defined distance, loss of protective coverage or an authority route opening.
Avoid broadcasting unnecessary details of defensive arrangements on open channels.
A controlled scenario
A product tanker at an outer anchorage receives a warning of an approaching suspicious craft. Engines can be ready in eight minutes, but the nearest traffic lane is congested and satellite positions disagree.
The master raises readiness, verifies position by radar and visual bearings, alerts authorities and prepares to slip rather than recover the full cable. The forecastle team remains protected until propulsion and an initial clear route are confirmed. When the contact is verified as hostile and authorities clear traffic, the team executes the planned release and the bridge reports the abandoned gear position.
This is a hypothetical training scenario, not a forecast or account of a specific attack.
Commercial conclusion
Emergency anchor departure is a balance of clocks: threat arrival, machinery readiness, anchor release, traffic clearance and route verification. The fastest physical release is not always the fastest path to safety.
Owners should define ship-specific weigh, slip and extreme-release plans. Masters need tested machinery and authority to leave or remain. Ports and naval forces need accurate readiness and ground-tackle reports. Charterers and insurers need the chronology, not hindsight.
ZeaClub can track threat reports, readiness, decision triggers, authority communications and abandoned equipment. It cannot order release, approve a route or replace the master's navigation judgment.
This article distinguishes verified source material from ZeaClub analysis, recommendations, forecasts and hypothetical scenarios.
Sources
- Industry Guidance on the Safe Management of Vessel Transit through the Strait of Hormuz, May 2026Accessed 2026-11-19
- JMIC Advisory Note, 5 March 2026Accessed 2026-11-19
- International Maritime Organization, COLREG overviewAccessed 2026-11-19
- International Maritime Organization, Maritime Security FAQsAccessed 2026-11-19
- International Maritime Organization, Ships' routeingAccessed 2026-11-19
- International Maritime Organization, Places of refugeAccessed 2026-11-19